Interface Range <Interface Type> <Slot/Port> - <Slot/Port - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
interface range <interface type> <slot/port> - <slot/port>
Use the interface range command to enter configuration mode for a range of interfaces.
Syntax Description
<interface type>
<slot/port>
<slot/port>
Default Values
No default value is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000, and Total Access 900 Series units.
Command History
Release 6.1
Release 11.1
Functional Notes
All configuration changes made in this mode will apply to all interfaces in the range specified.
Usage Examples
The following example selects seven consecutive Ethernet ports for configuration:
(config)#interface range eth 0/1-0/7
(config-eth 0/1-7)#
The following example selects nonconsecutive FXS ports for configuration:
(config)#interface range fxs 3/1-2, 3/3, 3/4-6, 3/8
(config-fxs 3/1-2, 3/3, 3/4-6, 3/8)#
61200510L1-35E
Specifies the interface type (e.g., ethernet, gigabit ethernet, etc.).Type interface
range ? for a complete list of valid interfaces.
Specifies the slot/port number of the first interface in the desired range of
interfaces to be configured, followed by a hyphen (-) or a comma (,).
Specifies the slot/port number of the last interface in the desired range of
interfaces to be configured.
Command was introduced.
Command was expanded to include FXO range.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
391