Clutch Controls - Clutch Master Cylinder
Removal and Installation
General Equipment
Syringe
Transit/Tourneo Connect 2002.5 (06/2002-)
Removal
1. Remove the battery.
For additional information, refer to:
(414-01 Battery, Mounting and Cables, Removal
and Installation).
2. Remove the air cleaner.
For additional information, refer to:
(303-12 Intake Air Distribution and Filtering,
Removal and Installation).
3. Remove the central junction box (CJB).
4. Remove the brake fluid reservoir cap.
CAUTION: If brake fluid is spilt on the
5.
paintwork, the affected area must be
immediately washed down with cold water.
Using a suitable
syringe
the brake fluid reservoir until the brake fluid level
is at MIN mark.
6. Install the brake fluid reservoir cap.
CAUTION: Cap the clutch slave cylinder
7.
supply line to prevent fluid loss and dirt
ingress.
NOTE: Remove the locking plates to
disconnect the hoses.
NOTE: Do not remove the bolt between the
two hoses.
Disconnect the clutch master cylinder hoses.
1. Detach the clutch master cylinder supply
hose from the clutch master cylinder and
position it to one side.
http://vnx.su
Print
Battery
Air Cleaner
, remove brake fluid from