Monitoring Events - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Monitoring Events

show snmp agent
show snmp management-event
178
To view the status of the SNMP agent, use the following show snmp agent command.
To view statistics associated with events, resources, and triggers, use the show snmp
management-event command.
Use to view SNMP MIB agent information.
Field descriptions
context name—Router that contains the MIB agent
access permission level—Access permission level for other virtual routers that may
want to access the agent
snmp proxy—Proxy gateway through which other virtual routers may access the
agent
Example
host1#show snmp agent
context name: router1
access permission level: no access
snmp proxy: enabled
See show snmp agent.
Use to view statistical SNMP event information for event table entries, router resources,
and trigger table entries.
Omit the events, resource, statistics, or triggers options to obtain a full output.
Field descriptions
Resource
SampleMinimum—Minimum number of samples to be taken
SampleInstanceMaximum—Maximum number of samples to be taken
SampleInstances—Number of sample instances being monitored
SampleInstancesHigh—Highest number of samples taken for any of the sample
instances
SampleInstancesLacks—Number of times this system could not take a new sample
because that allocation would have exceeded the limit set by
mteResourceSampleInstanceMaximum
Triggers
Owner—Owner value assigned to the trigger
Name—Name value assigned to the trigger
Copyright © 2010, Juniper Networks, Inc.