Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 265

show snmp trap statistics
Copyright © 2010, Juniper Networks, Inc.
Example
host1# show snmp trap
Enabled Categories: Bgp, Ospf, Sonet
SNMP authentication failure trap is disabled
Trap Source: FastEthernet 6/0, Trap Source Address:172.27.120.78
Trap Proxy: enabled
Global Trap Severity Level: 7 - debug
Trap Severity Level
-------------------
7 - debug
Address Security String
--------------- -------------------
192.168.1.10 public
Address TrapSeverityFilter
------------ ------------------ ------- --------- --------- -------------
192.168.1.10 2 - critical
See show snmp trap.
Use to display statistics for all SNMP traps on the virtual router, as well as statistics
for each SNMP host configured on the virtual router.
Field descriptions
Trap request(s)—Number of local traps requested
Proxy trap request(s)—Number of proxy traps requested
Trap(s) discarded—Total number of traps discarded
No system memory—Traps discarded because there was not enough system
memory
No queue resources—Traps discarded because there were no queue resources
available
SNMP agent disabled—Traps discarded because the SNMP agent was disabled
Global trap category disabled—Traps discarded because they were filtered by the
snmp enable trap command
Global minimum severity level—Traps discarded because they did not match the
severity level set with the snmp enable traps trapfilters command.
Trap(s) out—Total number of traps sent by the virtual router
Trap(s) proxied—Total number of traps proxied by the virtual router
Address—IP address of the host
TrapCategories
-------------------
ospf
Ver Port
--- -----
v1 162
Ping Maximum
TimeOut QueueSize DrainRate discrd methd
1 32
Chapter 4: Configuring SNMP
Trap Categories
----------------
BgpOspf
Queue Queue Full
0 dropLastIn
235