Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 103

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Parent Group
Configuration
Policy List Configuration
Policy List Parent Group
Configuration
Policy Parameter
Configuration
PPPoE Service Name
Table Configuration
Privileged Exec
Copyright © 2010, Juniper Networks, Inc.
Access to Mode
Configure an external
parent group.
Configure policy lists.
Configure an internal
parent group in a
hierarchy.
Configure a policy
parameter.
Configure services for a
PPPoE service name
table.
Show system information.
Set operating parameters.
Access Global
Configuration mode.
Exit from Mode
From Global Configuration
mode, use the
parent-group command.
Prompt:
host1(config-parent-group)#
To create a policy list,
from Global Configuration
mode use the policy-list
command and identify the
type of policy list.
Prompt:
host1(config-policy-list)#
From Global Configuration
Mode, use the policy-list
command to create or
access a policy list. From
Policy List Configuration
Mode, use the
parent-group command.
Prompt:
host1(config-policy-l
ist-parent-group)#
From Global Configuration
mode, use the
policy-parameter
command.
Prompt:
host1(config-policy-parameter)#
From Global Configuration
mode, use the
pppoe-service-name-table
command, and specify the
alphanumeric name of the
PPPoE service name table.
Prompt:
host1(config-pppoe-service-
name-table)#
From User Exec mode, use
the enable command.
Prompt:
host1#
Chapter 2: Command-Line Interface
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the disable command to
return to User Exec mode.
Use the exit command to log out
of the CLI.
Use the configure command to
enter Global Configuration mode.
73