Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 245

Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy
Schema (continued)
Bulkstats Output
Column Name MIB File
ifInErrors RFC1213
ifInUnknownProtos RFC1213
Copyright © 2010, Juniper Networks, Inc.
MIB Object Name CLI Configuration
ifInErrors in-errors
ifInUnknownProtos in-unknown-protos
Chapter 4: Configuring SNMP
Description
For packet-oriented
interfaces, the number of
inbound packets that
contained errors preventing
them from being deliverable
to a higher-layer protocol.
For character- oriented or
fixed-length interfaces, the
number of inbound
transmission units that
contained errors preventing
them from being deliverable
to a higher-layer protocol
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
For packet-oriented
interfaces, the number of
packets received via the
interface which were
discarded because of an
unknown or unsupported
protocol. For
character-oriented or
fixed-length interfaces that
support protocol
multiplexing the number of
transmission units received
via the interface which were
discarded because of an
unknown or unsupported
protocol. For any interface
that does not support
protocol multiplexing, this
counter will always be 0
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
215