Rsvp Configuration Mode; Rtr Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

rib-out
run
sleep
synchronization
table-map
timers

RSVP Configuration Mode

RTR Configuration Mode

host1(config)#rtr 784078348
host1(config-rtr)#?
default
do
exit
frequency
help
hops-of-statistics-kept
log
macro
max-response-failure
no
operations-per-hop
owner
request-data-size
run
samples-of-history-kept
sleep
tag
Copyright © 2010, Juniper Networks, Inc.
Configure rib-out storage for all BGP peers
Run an exec mode command (alias command do)
Make the Command Interface pause for a
specified duration
Enable synchronization with the IGP
Specify a table map to map external entry
attributes into routing table
Configure the keep-alive interval and the hold-time
In this mode, you can create and configure MPLS Resource Reservation Protocol (RSVP)
parameters.
From Global Configuration mode, type mpls rsvp interface profile and the profileName,
and press Enter.
host1(config)#mpls rsvp interface profile sprint
host1(config-rsvp)#?
cleanup-timeout-factor
default
do
exit
help
log
macro
no
refresh-period
run
sleep
In this mode, you can configure Response Time Reporter (RTR) parameters. The RTR
feature allows you to monitor your network's performance and its resources by measuring
response times and the availability of your network devices.
From Global Configuration mode, type rtr and the mapNumber, and press Enter.
Set a command to its default(s)
Run an exec mode command (alias command run)
Exit from the current command mode
Specify the frequency interval
Describe the interactive help system
Specify the hops capture
Configure logging settings
Run a CLI macro
Specify the maximum number of consecutive failures
Negate a command or set its default(s)
Specify a number of operations per hop
Specify the owner of entry
Specify the request payload size
Run an exec mode command (alias command do)
Specify the maximum history samples
Make the Command Interface pause for a specified duration
Specify the user defined tag
Configure the timeout factor
Set a command to its default(s)
Run an exec mode command (alias command run)
Exit from the current command mode
Describe the interactive help system
Configure logging settings
Run a CLI macro
Negate a command or set its default(s)
Configure refresh period
Run an exec mode command (alias command do)
Make the Command Interface pause for a specified
duration
Chapter 2: Command-Line Interface
109