Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 384

JunosE 11.3.x System Basics Configuration Guide
slot state type admin
---- ------- ------- -------
0 --- --- ---
1 online LM-4 disabled (mismatch)--- 9-1-0b0-9.rel 1d08h:32m:29s
2 online LM-10A-ADV
3 --- --- ---
.......
Related
Documentation
354
spare
----- ------------- -------------
--- ---
enabled --- 10-1-0b1-6-A.rel 2d19h:29m:18s
---
Issue the slot replace command on the slot.
6.
host1(config)#slot replace 1
TIP: If the line module is in a redundancy group and you did not disable
redundancy in Step 1, the system switches to the spare line module. The
system reloads both the replaced line module and the spare line module
when you issue the slot replace command.
NOTE: If you specify the slot replace command to replace an ES2 4G LM
with a different type of module without erasing the interface configuration
on slots that contain line modules that are members of a high availability
pair, an error message is displayed. The error message indicates that you
must deactivate high availability feature for the applicable line modules
before erasing or replacing the slot configuration. You need to use the no
mode high-availability slot command to disable high availability for the
slots in which those line modules reside.
If you disabled redundancy for the slot in Step 1, enable redundancy when the
7.
replacement line module has come online.
host1(config)#no redundancy lockout 1
(Optional) If the following settings were configured before replacing the module,
8.
reconfigure the settings:
a. Configure the Ethernet physical interface configuration using an SNMP set request
for entPhysicalAssetID and entPhysicalAlias.
b. Specify the threshold values for specific interface types for the slot.
host1(config)#resource if-type ip slot 1 threshold
redundancy lockout
resource if-type
slot accept
slot replace
snmp-server
running
release slot uptime
---
--- ---
Copyright © 2010, Juniper Networks, Inc.