Dos Protection Group Configuration Mode; Drop Profile Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

DoS Protection Group Configuration Mode

Drop Profile Configuration Mode

host1(config)#drop profile
host1(config-drop-profile)#?
average-length-exponent
committed-threshold
Copyright © 2010, Juniper Networks, Inc.
From Domain-Map Configuration mode, type tunnel and a tunnelNumber, and press
Enter.
host1(config-domain-map)#tunnel 17
host1(config-domain-map-tunnel)#?
address Configure tunnel endpoint address
client-name Configure the client hostname of the tunnel
default Set a command to its default(s)
exit Exit from the current command mode
do Run an exec mode command (alias command run)
help Describe the interactive help system
hostname Configure the client hostname of the tunnel
identification Configure tunnel identification
log Configure logging settings
macro Run a CLI macro
max-sessions Configure maximum sessions for this tunnel
medium Configure tunnel medium
no Negate a command or set its default(s)
password Configure tunnel password
preference Configure tunnel preference
run Run an exec mode command (alias command do)
server-name Configure the remote hostname for the tunnel
sleep Make the Command Interface pause for a specified duration
source-address Configure tunnel source address
type Configure tunnel type
In this mode, you can configure parameters for Denial of Service (DoS) protection groups.
From Global Configuration mode, type the dos-protection-group command and press
Enter.
host1(config)#dos-protection-group
host1(config-dos-protection)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
priority Specify the priority
protocol Specify the protocol
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
use Configure usagehost1(config-dos-protection-group)#?
In this mode, you can configure drop profiles for QoS. Drop profiles control RED dropping
behavior.
From Global Configuration mode, type the drop-profile command, and press Enter.
Select TAQL coefficient
Specify committed queue thresholds and maximum drop
probability
Chapter 2: Command-Line Interface
87