Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 331

exclude-subsystem
show subsystems
Copyright © 2010, Juniper Networks, Inc.
Use to exclude any subsystems that are in a release that you do not need for the system
configuration.
Example
host1(config)#exclude-subsystem coc12
The subsystems that you indicate are added to the " exclude list." All subsequent
release copies will exclude the images for these subsystems from the release copy.
Example
host1(config)#no exclude-subsystem coc12
Use the no version of this command with the subsystem name to remove a subsystem
from the exclude list. Use the no version of this command without a subsystem name
to remove all subsystems from the exclude list.
See exclude-subsystem.
Use to determine which subsystems are included in the current software release on
the system or in a specified software release file.
Specify either a local filename or a remote path and filename to view the subsystems
that are included in a software release file other than the current software release on
the system.
Field descriptions
Required—Number of bytes of data for the required portion of the release.
Included Subsystems—Number of bytes of data for the included subsystems listed.
All included subsystems in the release are listed.
Excluded Subsystems—Number of bytes of data for the excluded subsystems listed.
All excluded subsystems in the release are listed.
Use the command before you copy a release to verify which subsystems are present
in the release.
Example
host1#show subsystems file m:/x/images/x-y-z.rel
oc3
oc12p
oc12a
ge
fe8
coc12
oc12s
Use the command after copying a release to verify which subsystems are included and
excluded.
Example
Chapter 5: Managing the System
301