Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 286

JunosE 11.3.x System Basics Configuration Guide
service show-config
show configuration
host1# show configuration
! Configuration script being generated on TUE JAN 29 200X 00:31:12 UTC! Juniper Networks Edge Routing
Switch ERX-700
! Version: x.y.z (January 18, 200X 15:01)
! Copyright (c) 1999-200X Juniper Networks, Inc. All rights reserved.
Commands displayed are limited to those available at privilege level 10
! Juniper Networks Edge Routing Switch ERX-700
boot config running-configuration
boot system erx_x-y-z.rel
256
NOTE: When you specify categories with the show configuration command,
the output might display additional configuration data that is not explicitly
associated with the categories that you specified.
Use to define the show configuration command display output.
Specify format 1 to display the show configuration command output in its original
format.
Specify format 2 to significantly reduce the amount of time it takes to generate and
display output for configurations that contain three or more virtual routers and a large
number of interfaces.
Example
host1#service show-config format 2
Use the no version to revert the show configuration command output format to its
default (format 1).
See service show-config.
Use to display the current configuration of the system, a specified virtual router, a
specified interface, or a specified category of router settings.
This command was formerly documented as show config; that abbreviation is still
supported.
You can create a configuration script from the output by saving it as a file with the .scr
extension.
This command provides configuration information based on the privilege level of the
session (user). The output does not display any configuration data for commands that
have privilege levels higher than that of the session. For example, if the session is
enabled at level 5, issuing the show configuration command displays only output for
commands at level 5 and below. For more information, see "CLI Command Privileges"
on page 49.
You can use the output filtering feature of the show command to include or exclude
lines of output based on a text string you specify. See "Command-Line Interface" on
page 27, for details.
Example
Copyright © 2010, Juniper Networks, Inc.