Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 221

bulkstats interface-type
Copyright © 2010, Juniper Networks, Inc.
Use the no version to return to the proprietary method of encoding.
See bulkstats interfaces description-format common.
Use to configure the interface or subinterface type on which you want to collect
statistics.
You can provide an interface specifier (location) to identify a specific interface on
which you want to collect statistics.
If you define more than one collector, you must specify a unique collector index, in the
range 1–65535.
The supported interface types are:
atm—Collects statistics on ATM interfaces
atm1483—Collects statistics on ATM 1483 interfaces
ethernet—Collects statistics on Ethernet interfaces
frame-relay—Collects statistics on Frame Relay interfaces
frame-relay-sub—Collects statistics on Frame Relay subinterfaces
hdlc—Collects statistics on Cisco HDLC interfaces
ip—Collects statistics on IP interfaces
mplsMajor—Collects statistics on MPLS major interfaces
mplsMinor—Collects statistics on MPLS minor interfaces
mplsL2shim—Collects statistics on MPLS shim interfaces
ppp—Collects statistics on PPP
vlan—Collects statistics on VLAN subinterfaces
NOTE: You cannot collect statistics on the SRP Ethernet interface.
Example 1
host1(config)#bulkstats interface-type ppp 3/1 collector 2
Example 2
host1(config)#bulkstats interface-type vlan 2/3:1 collector 1
Example 3
host1(config)#bulkstats interface-type mplsMajor 2/3:1 collector 1
Chapter 4: Configuring SNMP
191