Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 241

bulkstats schema subtree policy
bulkstats schema subtree qos
Copyright © 2010, Juniper Networks, Inc.
Use to collect IGMP usage data.
To collect IGMP statistics for one or more IGMP attributes, use the subtreelist keyword.
To retrieve the offset from the master interval at which the record was created for the
bulk statistics interface record, use the time-offset keyword.
Example—Configures the schema to collect the destination address and time-offset
attributes for IGMP.
host1(config)#bulkstats schema 4 subtree igmp dest-address time-offset
Use the no version to delete the specified schema.
See bulkstats schema subtree.
Use to collect statistics about a specified policy or a policy type, or based on color-coded
tags applied by a policy.
To collect statistics for a specified policy, use the policy-name keyword.
To collect data on input policies, local input policies, output policies, or secondary
output policies, use the policy-type keyword.
To collect statistics based on color-coded tags applied by a policy, use the
policy-subtreelist keyword.
You create policies using the policy-list command. For information, see the JunosE
Policy Management Configuration Guide
Example—Configures the schema to collect statistics for a policy named XMYpolicy
host1(config)#bulkstats schema 4 subtree policy policy-name XMYpolicy
Use the no version to delete the specified schema.
See bulkstats schema subtree policy.
Use to configure the bulk statistics schema to collect QoS statistics and configuration
information on egress queues belonging to different interface types.
To export egress queue statistics based on the queue attributes specified for the QoS
schema, use the subtreelist keyword.
To export the summarized QoS rate statistics over each S-VLAN or ATM virtual path,
use the export-summarized-stats keyword.
Specifying the export-summarized-stats keyword enables the export of the
summarized statistics over each S-VLAN or ATM virtual path. To ensure that you
successfully receive the summarized statistics, do not filter out the forward-rate and
aggregate-dropped-rate attributes from the egress queue data. To accomplish this,
use either the bulkstats schema subtree qos all command or the bulkstats schema
subtree qos forwarded-rate aggregate-dropped-rate command.
Example 1—Configures the QoS schema to export all egress queue attributes
host1(config)#bulkstats schema 4 subtree qos subtreelist all
Chapter 4: Configuring SNMP
211