Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 341

exception protocol ftp
exception source
reload
show exception dump
Copyright © 2010, Juniper Networks, Inc.
Use to specify the gateway through which the system sends the core dump file to the
FTP server.
Example
host1(config)#exception gateway 10.10.1.15
Use the no version to return the value to its default (null).
See exception gateway.
Use to set a username and password for FTP access to the server where you transferred
a core dump file. The default settings are the username anonymous and no password.
Specify the number 8 before the username and before the password to encrypt these
values. By default, the username and password are not encrypted.
Example
host1(config)#exception protocol ftp 8 user_core 8 user_password
Use the no version to restore the default settings.
See exception protocol ftp.
Use to set the IP address and mask of the system interface over which you want to
send the core dump file to the FTP server.
You can optionally include an IP address mask.
Example
host1(config)#exception source 192.168.1.33 255.255.255.0
Use the no version to return the value to its default, null.
See exception source.
Use to reload the software on the router immediately.
Reloads the system software (.rel) file and the configuration (.cnf) file.
Reloading the standby SRP causes high availability to be temporarily disabled until
the standby SRP reloads and resynchronizes with the active SRP.
Example
host1#reload
There is no no version.
See reload.
Chapter 5: Managing the System
311