Ip Hosts; Trap Categories - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

IP Hosts

Trap Categories

Copyright © 2010, Juniper Networks, Inc.
Trap Severity Levels on page 158
Specifying an Egress Point for SNMP Traps on page 163
Configuring Trap Queues on page 163
Configuring Trap Notification Logs on page 164
Recovering Lost Traps on page 166
The system generates SNMP traps according to operating specifications defined in
supported MIBs.
Traps are sent to IP hosts. The IP hosts are configured in a proprietary trap host table
maintained by the router (the server). Each entry in the table contains:
IP address of the trap destination
Community name (v1 or v2c) or username (v3) to send in the trap message
SNMP format (v1 or v2) of the notification (trap) PDU to use for that destination
Types of traps enabled to be sent to that destination
Trap filters configured for the destination
The maximum number of entries in the SNMP trap host table in each virtual router is
eight.
The router supports the following trap categories:
addrPool—Local address pool traps
atmPing—E Series router proprietary ATM ping traps
bfdmib—BFD MIB traps
bgp—BGP state change traps
bulkstats—Bulk statistics file full and nearly full traps
cliSecurityAlert—Security alert traps
dhcp—Dynamic Host Configuration Protocol traps
dismanEvent—Distributed management (disman) event traps
dosProtectionPlatform—DoS protection platform traps
dvmrp—Distance Vector Multicast Routing Protocol traps
dvmrpProp—E Series router proprietary DVMRP traps
environment—Power, optical power, temperature, fan, and memory utilization traps
fileXfer—File transfer status change traps
haRedundancy—High availability and redundancy traps
inventory—System inventory and status traps
Chapter 4: Configuring SNMP
157