Igmp Schema Objects - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Copyright © 2010, Juniper Networks, Inc.
Table 25: if-stats Schema Objects (continued)
Object
in-unknown-protos
lower-interface
out-bcast-pkts
out-discards
out-errors
out-mcast-octets
out-mcast-pkts
out-octets
out-policed-octets
out-policed-pkts
out-sched-octets
out-sched-pkts
out-ucast-pkts
time-offset
All the schema if-stats objects in Table 25 on page 204 apply to both layer 2 and layer 3
interfaces, except usdAcctngSpoofedPkts, which is specific to layer 3.
Defining all interface types before you map a collector to the if-stats schema ensures
that you display statistics for all configured interfaces in the first interval.
You can get more accurate rate statistics by using the time-offset parameter. To use
this parameter you must navigate to the if-stats subtreelist. The time-offset parameter
is included in each bulk statistics interface record and is the offset from the master interval
at which the record was collected.

IGMP Schema Objects

Table 26 on page 206 describes the IGMP objects that you can configure using the bulkstats
schema subtree igmp command.
Definition
Configure If-stats schema for in-unknown-protos
Configure If-stats schema for lower-interface
Configure If-stats schema for out-bcast-pkts
Configure If-stats schema for out-discards
Configure If-stats schema for out-errors
Configure If-stats schema for out-mcast-octets
Configure If-stats schema for out-mcast-pkts
Configure If-stats schema for out-octets
Configure If-stats schema for out-policed-octets
Configure If-stats schema for out-policed-pkts
Configure If-stats schema for out-sched-octets
Configure If-stats schema for out-sched-pkts
Configure If-stats schema for out-ucast-pkts
Configure If-stats schema for time-offset
Chapter 4: Configuring SNMP
205