Managing And Monitoring Resources; Enabling And Disabling The Resource Threshold Monitor - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide
show tech-support

Managing and Monitoring Resources

Enabling and Disabling the Resource Threshold Monitor

resource if-type
320
Use to display technical support information used by Juniper Networks customer
support personnel to assist in troubleshooting the router.
Example
host1#show tech-support
Show Technical Support
---------------------------------------------------------------------------
System Name : host1
Time : THU JUL 15 2004 17:12:48 UTC
System up since : WED JUN 30 2004 16:07:51 UTC
Software release: 1088523900
Boot Flags : 0x100663296
Slot Number : 0
Serial Number : 7100170293
Assembly Number : 3400003701
Assembly Rev : A07
Description :
Command List:
CLI:show version
CLI:show boot
CLI:show hardware
CLI:show redundancy
CLI:show environment
CLI:show users detail
CLI:show utilization
CLI:show process cpu
CLI:show process memory
....
See show tech-support.
The resource threshold monitor (RTM) allows you to set the rising and falling thresholds
and trap hold-down times for certain interfaces. You can also view the resource threshold
information.
You may want to set thresholds for certain interface resources on the router. The RTM
allows you to specify rising and falling thresholds as well as hold-down times for certain
interfaces by using the resource if-type and resource threshold commands.
Use to specify rising and falling thresholds and hold-down times for certain interfaces
on a slot or systemwide basis.
Example
host1(config)#resource if-type ip slot 4 falling 500
Copyright © 2010, Juniper Networks, Inc.