Policy Schema Objects; Table 26: Igmp Schema Objects; Table 27: Policy Schema Objects - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide
206

Table 26: IGMP Schema Objects

Object Definition
all Configure IGMP schema for all attributes
dest-address Configure IGMP schema for destination address
igmp-cmd Configure IGMP schema for IGMP command
lower-interface Configure IGMP schema for lower interface
multicast-group Configure IGMP schema for multicast group
router-index Configure IGMP schema for router index
source-address Configure IGMP schema for source address
time-stamp Configure igmp schema for time stamp

Policy Schema Objects

Table 27 on page 206 describes the policy objects that you can configure using the bulkstats
schema subtree policy command.

Table 27: Policy Schema Objects

Object
all
green-bytes
green-packets
red-bytes
red-packets
upper-green-bytes
upper-green-packets
upper-red-bytes
upper-red-packets
upper-yellow-bytes
upper-yellow-packets
yellow-bytes
Definition
Configure policy schema for all statistics
Configure policy schema for green bytes
Configure policy schema for green packets
Configure policy schema for red bytes
Configure policy schema for red packets
Configure policy schema for upper green bytes
Configure policy schema for upper green packets
Configure policy schema for upper red bytes
Configure policy schema for upper red packets
Configure policy schema for upper yellow bytes
Configure policy schema for upper yellow packets
Configure policy schema for yellow bytes
Copyright © 2010, Juniper Networks, Inc.