Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 107

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Statistics Profile
Configuration
Subinterface
Configuration
Subscriber Policy
Configuration
Traffic Class
Configuration
Traffic Class Group
Configuration
Tunnel Group
Configuration
Copyright © 2010, Juniper Networks, Inc.
Access to Mode
Configure statistics
profiles.
Configure multiple virtual
interfaces on a single
physical interface.
Configure a nondefault
subscriber policy for a
subscriber (client) bridge
group interface.
Configure a traffic class.
Configure a traffic class
group.
Add up to 31 tunnel
definitions to a tunnel
group.
Exit from Mode
From Global Configuration
mode, use the
statistics-profile
command.
Prompt:
host1(config-statistics-
profile)#
From Global Configuration
mode, use the interface
command and identify the
interface
(slot/port.subinterface).
Prompt:
host1(config-subif)#
From Global Configuration
mode, use the
subscriber-policy
command and specify the
alphanumeric name of the
subscriber policy.
Prompt:
host1(config-policy)#
From Global Configuration
mode, use the
traffic-class command.
Prompt:
host1(config-traffic-class)#
From Global Configuration
mode, use the
traffic-class-group
command.
Prompt:
host1(config-traffic-class-
group)
From Global Configuration
mode, use the aaa
tunnel-group command
and specify the name of
the tunnel.
Prompt:
host1(config-tunnel-group)#
Chapter 2: Command-Line Interface
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
menu.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
77