Monitoring The System - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Monitoring the System

baseline show-delta-counts
show configuration
322
---------------------------
ip interface
ip interface
ip interface
atm-sub-if interface
atm-vc interface
ppp-link interface
ppp-link interface
ppp-link interface
atm-active-sub-if interface
type
---------------------------
ip interface
ip interface
ip interface
atm-sub-if interface
atm-vc interface
ppp-link interface
ppp-link interface
ppp-link interface
atm-active-sub-if interface
Example 2
host1#show resource threshold trap
Resource Threshold Trap: enabled
See show resource.
This section provides basic system commands that allow you to display information
about the router's state. The show configuration command, for example, allows you to
display the router's entire configuration.
Use to configure the system to always display statistics relative to the most recent
appropriate baseline.
The system collects many statistics during its operation. Various show commands are
available to display these statistics. Baselining allows the user to identify a point in
time relative to which such statistics can be reported.
Typically, the optional delta keyword is used with show commands to specify that
baselined statistics are to be shown. This command applies the " delta" function
implicitly.
Example
host1#baseline show-delta-counts
Use the no version to have access to the total statistics.
See baseline show-delta-counts.
-------- -------- -------
system 32000
slot 3 8192
slot 4 4095
system 65536
system 65536
system 32768
slot 3 2048
slot 4 6
system 65536
falling hold-down
location threshold
-------- --------- ---------
system 320
slot 3 82
slot 4 41
system 655
system 655
system 328
slot 3 20
slot 4 0
system 655
Copyright © 2010, Juniper Networks, Inc.
---------
1 28800
0 7373
0 3686
0 58982
0 58982
0 29491
0 1843
0 5
0 58982
time
300
300
300
300
300
300
300
300
300