Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 108

JunosE 11.3.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Tunnel Group Tunnel
Configuration
Tunnel Profile
Configuration
Tunnel Server
Configuration
User Exec
VRF Configuration
VR Group Configuration
78
Access to Mode
Configure attributes for a
tunnel group tunnel.
Configure tunnel profile
parameters.
Configure the maximum
number of tunnel-service
interfaces for a dynamic
tunnel-server port.
Change terminal settings
on a temporary basis.
Show system information.
Access Privileged Exec
mode.
Configure VRF
parameters for
BGP/MPLS VPNs.
Configure a virtual router
group for AAA broadcast
accounting.
Exit from Mode
From Tunnel Group
Configuration mode, use
the tunnel command and
specify the tag value (1-31)
of the tunnel.
Prompt:
host1(config-tunnel-group-
tunnel)#
From Global Configuration
mode, specify the mpls
tunnels profile command.
Prompt:
host1(config-tunnelprofile)#
From Global Configuration
mode, use the
tunnel-server command
and identify the slot/port
location of the dynamic
tunnel-server port.
Prompt:
host1(config-tunnel-server)#
Log into system.
Prompt:
host1>
From Global Configuration
mode, use the ip vrf
command.
Prompt:
host1(config-vrf)#
From Global Configuration
mode, use aaa accounting
vr-group to enter VR
Group Configuration
mode.
Prompt:
host1(config-vr-group)#
Copyright © 2010, Juniper Networks, Inc.
Use the exit command twice to
return to Global Configuration
Mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the enable command to enter
Privileged Exec mode.
Use the exit command to log out
of the CLI.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.