Subscriber Policy Configuration Mode; Traffic Class Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Subscriber Policy Configuration Mode

Traffic Class Configuration Mode

host1(config)#traffic-class test123
host1(config-traffic-class)#?
default
do
exit
fabric-strict-priority
help
log
macro
no
run
sleep
112
In this mode, you can configure a policy (a set of forwarding and filtering rules) that
defines how a subscriber (client) bridge group interface should handle various packet
types. After you define the policy, use the bridge subscriber-policy command (from
Global Configuration mode) to associate the policy with a bridge group interface.
From Global Configuration mode, type the subscriber-policy command followed by an
alphanumeric policy name of any character length, and press Enter.
host1(config)#subscriber-policy client1
host1(config-policy)#?
arp Modify arp policy
broadcast Modify broadcast policy
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
ip Modify ip policy
log Configure logging settings
macro Run a CLI macro
mpls Modify mpls policy
multicast Modify multicast policy
no Negate a command or set its default(s)
pppoe Modify PPPoE policy
relearn Modify relearn policy
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
duration
unicast Modify user-to-user (Unicast) policy
unknown-destination Modify unknown destination policy
unknown-protocol Modify unknown protocol policy
In this mode, you can create a traffic class and configure the level of service to packets
assigned to the traffic class.
From Global Configuration mode, type the traffic-class command followed by a
trafficClassName, and then press Enter.
Set a command to its default(s)
Run an exec mode command (alias command run)
Exit from the current command mode
Allow packets in this class to be dequeued out of the
fabric ahead of other traffic classes
Describe the interactive help system
Configure logging settings
Run a CLI macro
Negate a command or set its default(s)
Run an exec mode command (alias command do)
Make the Command Interface pause for a specified duration
Copyright © 2010, Juniper Networks, Inc.