Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 472

JunosE 11.3.x System Basics Configuration Guide
host1(config)# show suspicious-control-flow-detection flows
Suspicious Flow Detection System Flows
Interface Protocol
----------------- -------
GigabitEthernet 1/0/7 Ethernet ARP
*group 3 slot 1 EthernetArpMiss 0000.0100.0003 ---
show suspicious-control-flow-detection info
442
InSlot—For certain flows detected on egress, the possible ingress slot of the flow
Rate (pps)—Rate of the flow
Peak Rate (pps)—Peak rate of the flow
Time Since Create—Time since the flow was determined to be suspicious, in
hh:mm:sec format
Example
MAC address
------------
0000.0100.0002 ---
See show suspicious-control-flow-detection flows.
Use to display information about suspicious flows.
You can specify the following keywords:
delta—Displays statistics for the current baseline
brief—Displays only suspicious information
slot—Displays information for the specific slot
Field descriptions
Protocol Information
Protocol—Control protocol of the flow
State
OK—Protocol is currently not receiving an excess amount of traffic.
Suspicious—Protocol detected as receiving an excess amount of traffic within
the last backoff time in number of seconds.
Transitions—Number of times this protocol or priority has transitioned to the
suspicious state
Priority Information
Priority—Priorities map to a specific queue and color; priority groups are Hi-Green,
Hi-Yellow, Lo-Green and Lo-Yellow.
State:
OK—Protocol is currently not receiving an excess amount of traffic
Peak Time
In Rate Rate since
Slot (pps) (pps) Create
----- --- ------- -------
1000030 1000050 00:00:32
1000 3000 00:10:10
Copyright © 2010, Juniper Networks, Inc.