Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 552

JunosE 11.3.x System Basics Configuration Guide
522
Last Update—Last time received from the master
Root Dispersion—Measure of all the errors associated with the network hops and
servers between the system and its stratum 1 server, in seconds
Configuration:
Admin. State—Status of NTP on the router (enabled or disabled)
Virtual Router Name—Name of the virtual router to which you attached NTP
Broadcast Delay—Time for a broadcast message to travel between the server and
the client, in microseconds
Client Mode—NTP client status (True – system is an NTP client; False – system
is not an NTP client)
Master Mode—NTP server status (True – system is configured as an NTP server;
False – system is not configured as an NTP server)
Stratum No.—Stratum number of system if configured as NTP server
Summer Time—Status of seasonal time, True or False
Summer Timezone Name—Name of summer time zone
Timezone Name—Name of time zone
Timezone Offset—Time difference between the time zone and UTC, in
hours:minutes
Access List—Identities of access lists of servers from which the system does not
accept broadcasts
'Server Source' Interface—Interface through which responses from the NTP server
are directed; configured through the ntp server source command, which overrides
the interface configured through the ntp source command.
'Client Source' Interface—Interface through which all NTP server responses are
directed; configured through the ntp source command.
Source Interface—IP address of the interface to which NTP servers should send
NTP responses
Address—IP address of interface
Enable—Status of NTP on the interface, On or Off
BcastClient—Indication of whether or not this interface accepts broadcasts from
NTP servers, On or Off
BcastServer—Indication of whether or not this interface functions as a broadcast
server, On or Off
Name—Type of interface and its location
Copyright © 2010, Juniper Networks, Inc.