Statistics Profile Configuration Mode; Subinterface Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Statistics Profile Configuration Mode

Subinterface Configuration Mode

Copyright © 2010, Juniper Networks, Inc.
host1(config)#snmp-server management-event
host1(config-mgmtevent)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
event Specify what happens when an event is triggered
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
resource Specify the resource limits
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
trigger Specify the conditions that lead to events
In this mode, you can configure a statistics profile. You can then set the rate period during
which statistics are gathered, enable statistics gathering, and enable the counting of
drop and forwarding events.
From Global Configuration mode, type statistics-profile and the statisticsProfileName
that you want to create or configure, and press Enter.
host1(config)#statistics-profile statpro-1
host1(config-statistics-profile)#?
committed-drop-threshold
conformed-drop-threshold
default
do
exceeded-drop-threshold
exit
forwarding-rate-threshold
help
log
macro
no
rate-period
run
sleep
In this mode, you can configure one or more virtual interfaces, called subinterfaces, on a
single physical interface. The system supports this feature with ATM and Frame Relay.
Both ATM and Frame Relay provide permanent virtual circuits (PVCs) that can be grouped
under separate subinterfaces configured on a single physical interface. Subinterfaces
allow multiple encapsulations for a protocol on a single interface.
From Interface Configuration mode, indicate a subinterface by typing the interface
command and an interfaceSpecifier in slot/port.subinterface format, and then press Enter.
For example:
host1(config-if)#interface atm 3/2.6
host1(config-subif)#
Set threshold for logging a committed-drop event
Set threshold for logging a conformed-drop event
Set a command to its default(s)
Run an exec mode command (alias command run)
Set threshold for logging an exceeded-drop event
Exit from the current command mode
Set threshold for logging a forwarding-rate event
Describe the interactive help system
Configure logging settings
Run a CLI macro
Negate a command or set its default(s)
Set the time period for calculating queue rates
Run an exec mode command (alias command do)
Make the Command Interface pause for a specified
duration
Chapter 2: Command-Line Interface
111