Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 106

JunosE 11.3.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Router Configuration
RSVP Configuration
RTR Configuration
Scheduler Profile
Configuration
Service Session Profile
Configuration
SNMP Event Manager
Configuration
76
Access to Mode
Configure a routing
protocol.
Configure an RSVP
profile.
Configure RTR
parameters.
Configure shaping
parameters.
Configure scheduler
profiles.
Configure attributes for
Service Manager service
session profiles.
Configure SNMP events.
Exit from Mode
From Global Configuration
mode, specify a routing
protocol with the router
command.
Prompt:
host1(config-router)#
From Global Configuration
mode, use the mpls rsvp
profile command.
Prompt:
host1(config-rsvp)#
From Global Configuration
mode, use the rtr
command.
Prompt:
host1(config-rtr)#
From Global Configuration
mode, use the
scheduler-profile
command.
Prompt:
host1(config-scheduler-
profile)#
From Global Configuration
mode, use the
service-management
service-session-profile
command.
Prompt:
host1(config-service-session-
profile)#
From Global Configuration
mode, use the
snmp-server
management-event
command.
Prompt:
host1(config-mgmtevent)#
Copyright © 2010, Juniper Networks, Inc.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
menu.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
menu.