Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 102

JunosE 11.3.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Layer 2 Control Neighbor
Configuration
LDP Configuration
Line Configuration
Local IPSec Transport
Profile Configuration
Local User Configuration
Map Class Configuration
Map List Configuration
72
Access to Mode
Configure ANCP (L2C)
neighbor parameters.
Configure MPLS LDP
profile parameters.
Modify a virtual terminal
line.
Configure preshared IKE
keys for L2TP over IPSec
profiles.
Configure user
parameters in local user
databases.
Specify fragmentation for
a map class.
Configure map list
parameters.
Exit from Mode
From Layer 2
Configuration mode, use
the neighbor command.
Prompt:
host1(config-l2c-
neighbor)#
From Global Configuration
mode, specify the mpls
ldp profile command.
Prompt:
host1(config-ldp)#
From Global Configuration
mode, use the line
command.
Prompt:
host1(config-line)#
From the IPSec Transport
Profile Configuration
mode, use the local ip
address command.
Prompt:
host1(config-ipsec-transport-
profile-local)#
From Global Configuration
mode, specify the aaa
local username or the aaa
local database command.
Prompt:
host1(config-local-user)#
From Global Configuration
mode, specify the
map-class frame-relay
command.
Prompt:
host1(config-map-class)#
From Global Configuration
mode, use the map-list
command.
Prompt:
host1(config-map-list)#
Copyright © 2010, Juniper Networks, Inc.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command to return
to Global Configuration mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.