Tunnel Profile Configuration Mode; Tunnel Server Configuration Mode; Vrf Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Tunnel Profile Configuration Mode

Tunnel Server Configuration Mode

VRF Configuration Mode

114
macro Run a CLI macro
max-sessions Configure maximum sessions for this tunnel
medium Configure tunnel medium
no Negate a command or set its default(s)
password Configure tunnel password
preference Configure tunnel preference
receive-window Configure the receive window size for this tunnel
router-name Configure the virtual-router for the domain name
run Run an exec mode command (alias command do)
server-name Configure the remote hostname for the tunnel
sleep Make the Command Interface pause for a specified duration
source-address Configure tunnel source address
type Configure tunnel type
In this mode, you can create and configure MPLS tunnel profiles.
From Global Configuration mode, type mpls tunnels profile and the profileName, and
press Enter.
host1(config)#mpls tunnels profile storm
host1(config-tunnelprofile)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
tunnel Configure tunnel interface parameters
In this mode, you can configure (provision) the maximum number of tunnel-service
interfaces to be used on a dynamic tunnel-server port.
From Global Configuration mode, type tunnel-server and the slot number and port
number of the dynamic tunnel-server port, and press Enter.
host1(config)#tunnel-server 2/2
host1(config-tunnel-server)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
max-interfaces Configure maximum number of tunnel-server interfaces for
dynamic server port
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can create and configure VRF parameters for BGP/MPLS VPNs.
Copyright © 2010, Juniper Networks, Inc.