Configuring The Display Terminal; Specifying The Character Set - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Configuring the Display Terminal

terminal length
terminal width

Specifying the Character Set

data-character-bits
270
You can specify the number of lines that appear on a terminal screen and the number of
characters that appear on a line.
Use to set the number of lines on a screen.
If a command generates more lines than the number configured, the output pauses
after each screen.
Set the number of lines on a screen in the range 0–512.
Use 0 for no pausing.
Example
host1#terminal length 25
There is no no version.
See terminal length.
Use to set the width of the display terminal.
Set the number of characters on a screen line in the range 30–512.
Example
host1#terminal width 80
There is no no version.
See terminal width.
You can specify the number of data bits per character for the current vty session and for
all subsequent sessions on the specified vty lines. This feature allows you to display
international characters on the terminal's screen.
Use to set the number of bits per character on the terminal's screen for all future
sessions on the specified lines.
Use the default setting, 8, to view the full set of 8-bit international characters. Be sure
that the software on other devices in the network also supports international characters.
Set the number of bits to 7 to view only characters in the standard ASCII set.
Example
host1(config)#line vty 1 3
host1(config-line)#data-character-bits 7
Copyright © 2010, Juniper Networks, Inc.