Terminating An Ssh Session - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide
id username host
3 mcarr 10.0.0.145
430
id—Session ID number
username—Username for the remote user that initiated the session
host—IP address of the remote client
uptime (d:h:m:s)—Duration of the session
client version—Version of the SSH software run by the remote client
ciphers inbound/outbound—Encryption algorithms used by the client and the
system for this session
MAC inbound/outbound—Message authentication code algorithms used by the
client and the system for this session
Example
host1#show ip ssh detail
SSH Server version: SSH-2.0-2.0.12
SSH Server status: enabled, up since THU JUL 24 2008 16:01:17 UTC
supported encryption, inbound: 3des-cbc,blowfish-cbc,twofish-cbc
supported encryption, outbound: 3des-cbc,blowfish-cbc,twofish-cbc
supported MAC, inbound: hmac-sha1,hmac-sha1-96,hmac-md5
supported MAC, outbound: hmac-sha1,hmac-sha1-96,hmac-md5
user authentication: enabled
user authentication protocol: TACACS+
retry limit: 20
sleep period: 600
timeout: 600
connections since last system reset: 4 out of 4 attempts
connections since daemon startup:
active sessions: 1
uptime
(d:h:m:s) client version
0:00:00:19 SSH-2.0-2.0.12
F-SECURE SSH
To view failed connection attempts and other protocol errors logged at the error severity
level, use the show log data command:
host1#show log data category ssh severity error
See show ip ssh.

Terminating an SSH Session

You can use the session identifier to terminate an SSH session.
4 out of 4 attempts
ciphers MAC
inbound/outbound inbound/outbound
3des-cbc/3des-cbc hmac-md5/hmac-md5
Copyright © 2010, Juniper Networks, Inc.