Map Class Configuration Mode; Map List Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Map Class Configuration Mode

Map List Configuration Mode

Copyright © 2010, Juniper Networks, Inc.
host1(config)#aaa local username curt38 database westLocal12
host1(config-local-user)#?
default
do
exit
help
ip-address
ip-address-pool
log
macro
no
operational-virtual-router
password
run
secret
sleep
support
In this mode, you can specify Frame Relay End-to-End fragmentation and reassembly
for a map class. Optionally, you can specify the maximum payload size of a fragment or
specify fragmentation only or reassembly only.
From Global Configuration mode, type the map-class frame-relay command and the
mapClassName you want to configure, and press Enter.
host1(config)#map-class frame-relay testmapclass
host1(config-map-class)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
frame-relay Configure frame relay parameters
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can configure map list parameters. In Map List Configuration mode,
commands such as map-list and ip atm-vc are used to configure ATM NBMA interfaces.
From Global Configuration mode, type map-list and a mapListName, and press Enter.
host1(config)#map-list mjt3330
host1(config-map-list)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
ip Add IP address to the map
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
Chapter 2: Command-Line Interface
Set a command to its default(s)
Run an exec mode command (alias command run)
Exit from the current command mode
Describe the interactive help system
Specify an IP address for the user
Specify an IP address pool for the user
Configure logging settings
Run a CLI macro
Negate a command or set its default(s)
Specify an operational virtual router for the
user
Configure the password
Run an exec mode command (alias command do)
Configure the secret
Make the Command Interface pause for a specified
duration
Enter Support mode
99