Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 56

JunosE 11.3.x System Basics Configuration Guide
26
You can configure the router to act as an LAC in PPP pass-through mode. The router
creates tunnels dynamically by using AAA authentication parameters and transmits
L2TP packets to the LNS through IP/UDP. See JunosE Broadband Access Configuration
Guide.
Non-PPP equal access—A method of allowing remote access in which the router
provides IP addresses to subscribers' computers through Dynamic Host Configuration
Protocol (DHCP). This method is particularly convenient for broadband (cable and
DSL) environments or environments that use bridged Ethernet over ATM, because
network operators can support one central system rather than an individual PPPoE
client on each subscriber's computer. See JunosE Broadband Access Configuration
Guide.
Copyright © 2010, Juniper Networks, Inc.