Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 293

service check-config auto-recover
service check-config running-configuration
service check-config running-configuration recover
Copyright © 2010, Juniper Networks, Inc.
configuration resumes. If recovery fails, load another release on the primary SRP and
run the reload force command. The primary and standby SRP modules re-initiate
during a reboot.
If the file systems on both the primary and standby SRPs are corrupt when HA is
enabled, the following changes occur:
File Synchronization–Configuration files are not synchronized when the HA state
changes to disabled and the synchronization state is not restored until the successful
recovery of the corrupted files or the recovery window is complete.
HA–HA is disabled during recovery and the state is restored on successful recovery.
Unified ISSU–If unified ISSU is in the idle state, the operation is disabled until
successful recovery or the recovery window is complete. The unified ISSU process
continues if it has started.
Auto-Recovery—Monitoring of corrupt configuration stops on both the primary and
standby SRP modules and a message appears indicating whether the files are
recoverable. If the SRPs are successfully recovered, monitoring of corrupt
configuration resumes. If recovery fails, load another release on the primary SRP and
run the reload force command. The primary and standby SRP modules re-initiate
during a reboot.
Use to enable auto-recovery of files in the running configuration that are corrupted
due to a fatal duplicate key error or the existence of values such as 0XFF and 0x00 in
sectors of a Flash. You cannot auto-recover CNF files on the primary and standby SRPs.
Example
host1(config)#service check-config auto-recover
Use the no version without the auto-recover option to restore the default action,
manual detection.
See service check-config.
Use to view a list of corrupt files in the running configuration and the files that are
recoverable on the primary SRP and the standby SRP.
Example
host1(config)#service check-config running-configuration
Use the no version without the running-configuration option to restore the default
action, manual detection.
See service check-config.
Chapter 5: Managing the System
263