Monitoring Pim Events; Monitoring Pim Settings - Juniper JUNOSE 11.0.X MULTICAST ROUTING Configuration Manual

Monitoring PIM Events

You can use the debug PIM commands to view information about PIM events.
debug ip pim
undebug ip pim

Monitoring PIM Settings

You can use the show ip pim commands to display information about PIM settings.
show ip pim
Use to show information about the selected event.
To control the type of events displayed, specify a severity level.
To control how much information to display, specify a verbosity level.
Example
host1#debug ip pim events severity 1 verbosity low
Use the no version to disable the display.
See debug ip pim.
Use to turn off the display of information previously enabled with the debug ip
pim command.
Example
host1#undebug ip pim events
There is no no version.
See undebug ip pim.
Use to view general PIM router-level information.
Field descriptions
Default PIM Version Default PIM version number (always 2)
Default Domain Id Default Domain Id (always 0)
Default Hello period Default interval (in minutes) at which the router sends
hello messages to neighbors
Default Hello Hold Time Default time (in minutes) for which the router
keeps the neighbor state alive
Join-Prune Interval Interval value (in seconds) set in the join/prune message
originated by the PIM router
Chapter 3: Configuring PIM for IPv4 Multicast
Monitoring PIM
111