Installing Junose Software; Overview - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual
Software for e series broadband services routers system basics configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04:
- Configuration manual (304 pages) ,
- Reference manual (284 pages)
Table of Contents
Advertisement
CHAPTER 3
Installing JunosE Software
Overview
Copyright © 2010, Juniper Networks, Inc.
The JunosE Software resides on a nonvolatile storage (NVS) card located in the switch
route processor (SRP) module. Each SRP module is shipped with an NVS card that
contains a software release. New software releases are available for download from the
Juniper Networks website at
downloaded image bundle to create your own software CDs.
CAUTION: See the Release Notes for extra information about installing and
upgrading the software.
This chapter provides information on how to install a new software release on a router
and contains the following sections:
Overview on page 117
Platform Considerations on page 119
Installing Software When a Firewall Exists on page 119
Installing Software When a Firewall Does Not Exist on page 124
Copying Release Files from One Router to Another on page 130
Upgrading Systems That Are Operating with Two SRP Modules on page 131
Upgrading JunosE Software on page 133
Downgrading JunosE Software on page 135
If the router contains only one SRP module, we recommend you divert traffic to another
router before installing a new software release because the router is unavailable during
the installation process. Depending on whether a firewall separates the router from the
network host, you can then complete the appropriate software installation. (See "Installing
Software When a Firewall Exists" on page 119 or "Installing Software When a Firewall
Does Not Exist" on page 124.) However, if the router contains two SRP modules, you can
upgrade the software while the system is operating. (See "Upgrading Systems That Are
Operating with Two SRP Modules" on page 131.)
When installing new JunosE Software, you must copy the contents of the release files
to a network host and transfer the release files to at least one router in the network.
http://www.juniper.net/customers/support
. You can use the
117
Advertisement
Table of Contents
Troubleshooting
