Table 32: Categories Of Router Settings - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Copyright © 2010, Juniper Networks, Inc.
Table 32 on page 255 describes the categories of router settings and the type of information
displayed for each category.

Table 32: Categories of Router Settings

Category Configuration Displayed
aaa Authentication, authorization, and accounting (AAA) settings, such as
the default authentication protocol and the RADIUS accounting server
address-assignment Address assignment settings for Dynamic Host Configuration Protocol
(DHCP) and the local address server
flow-management Flow management settings, such as firewalls, Network Address
Translation (NAT), and IP flow statistics
interfaces Physical interfaces (types and specifiers); this is the only category that
displays information about interfaces
ip-protocols Internet protocols, such as Border Gateway Protocol (BGP) and Open
Shortest Path First (OSPF)
link-layer-forwarding Link-layer settings, such as bridged interfaces and link-layer interface
types
management Router management settings, such as the CLI, bulk statistics, and Telnet
physical-layer-protocols Physical layer protocols, such as DS1, DS3, and SONET/SDH
policy Policy settings, such as policy lists, classifier groups, and rate-limit
profiles
qos Quality of service (QoS) settings, such as traffic class, drop profile, and
scheduler profile
system System-level settings, such as timing, logging, and redundancy
tunneling Tunneling protocols, such as IP Security (IPSec), Multiprotocol Label
Switching (MPLS), and Layer Two Tunneling Protocol (L2TP)
Many of the categories described in Table 32 on page 255 contain subcategories of router
settings. For example, you can specify show configuration category management cli
to display only the configuration for the CLI. To display the names of subcategories that
you can specify for each category, issue the show configuration category categoryName
? command.
You can combine the category keyword with the virtual-router keyword to display the
current configuration of specific settings for a virtual router.
Chapter 5: Managing the System
255