Reformatting The Primary Flash Card - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

synchronize

Reformatting the Primary Flash Card

Copyright © 2010, Juniper Networks, Inc.
Use to force the NVS file system of the redundant SRP module to synchronize with
the NVS file system of the primary SRP module.
If you synchronize the redundant SRP module with the primary SRP module and the
redundant module is armed with a release different from the one it is currently running,
the redundant SRP module is automatically rebooted to load the armed release.
Optionally, you can use the low-level-check keyword to force the router to validate
all files or only configuration files in NVS, and to synchronize all files that failed the
checksum validation test during the flash-disk-compare command as well as any
other files that are unsynchronized.
When you use the low-level-check keyword, you must also specify one of the following
keywords:
all—Validates all files in NVS, and synchronizes all files that failed the checksum
test as well as any other unsynchronized files; this option can take several minutes
to complete.
configuration—Validates all configuration files in NVS, and synchronizes all files
that failed the checksum test as well as any other unsynchronized files; this option
takes less time to complete because it validates only a subset of the files in the NVS
file system.
If one or more of the following conditions exist when you use the low-level-check
keyword, the command fails and the router displays a message that explains why it
cannot perform the synchronization:
The router does not contain a redundant SRP module.
The redundant SRP module is offline.
The armed releases are different on the primary SRP and redundant SRP.
Examples
host1#synchronize
host1#synchronize low-level-check all
host1#synchronize low-level-check configuration
There is no no version.
See synchronize.
You can reformat the primary flash card. To do so:
Access Boot mode.
1.
a. From Privileged Exec mode, enter the reload command. Information about the
reloading process is displayed.
b. When the countdown begins, press the mb key sequence (case-insensitive).
Chapter 6: Managing Modules
373