Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 220

JunosE 11.3.x System Basics Configuration Guide
bulkstats collector primary-receiver
bulkstats collector secondary-receiver
bulkstats collector single-interval
bulkstats interfaces description-format common
190
Use the no version to set the size of the bulk statistics file to the default, 5767168 bytes.
See bulkstats collector.
Use to assign the primary receiver to which the system transfers data.
The index for the receiver must match the index that you specified with the bulkstats
receiver remote-name command.
Example
host1(config)#bulkstats collector 2 primary-receiver 7
Use the no version to clear the primary receiver and disable the collector.
See bulkstats collector.
Use to assign the secondary (that is, the backup) receiver to which the system transfers
data.
The index for the receiver must match the index you specified with the bulkstats
receiver remote-name command.
Example
host1(config)#bulkstats collector 2 secondary-receiver 5
Use the no version to clear the secondary receiver.
See bulkstats collector.
Use to set the system to retrieve bulk statistics once only, rather than periodically.
Example
host1(config)#bulkstats collector 2 single-interval
Use the no version to set the system to retrieve bulk statistics periodically, the default
situation.
See bulkstats collector.
Use to set the encoding scheme of the ifDescr object that the bulk statistics application
reports to the conventional industry method.
This command provides compatibility with software that uses the industry encoding
scheme.
For more information, see "Configuring Encoding Method" on page 152.
Example
host1(config)#bulkstats interfaces description-format common
Copyright © 2010, Juniper Networks, Inc.