Figure 25: Location Of The Software Reset Button - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

erase secrets
service unattended-password-recovery
Copyright © 2010, Juniper Networks, Inc.

Figure 25: Location of the Software Reset Button

NOTE: If you do not press the software reset button within the time limit,
the system will not erase the password, and you will need to repeat the
process.
Use to delete all CLI passwords and secrets.
After you issue this command, press the software reset button (see Figure 25 on
page 409) within the time you specify for this command.
Allows you to set the number of seconds (1–60) for this procedure to be accomplished.
Allows you to set a new password when you have forgotten your password.
Can be used with the service unattended-password-recovery command.
Example
host1>erase secrets 60
There is no no version.
See erase secrets.
Chapter 7: Passwords and Security
409