Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 329

show users
Copyright © 2010, Juniper Networks, Inc.
Example
host1#show ftp-server
FTP Server state: enabled, 0 open connections
Statistics since server was last started:
attempts: 32
failed hosts: 5
failed users: 7
Statistics since last system reload:
attempts: 35
failed hosts: 5
failed users: 8
See show ftp-server.
Use to display information about users of the vty lines.
Specify the all keyword to view information for all configured lines (both connected
and not connected).
Specify the detail keyword to view detailed information.
Field descriptions
line number—Number of the line to which the user is connected
line name—Name of the line, the service the line offers, and the relative line number
user—Name of the user
connected from—Location or IP address of the user
connected since—Date and time that the user connected to the line
idle time—Amount of time it has been since an entry was made from this line (detail
only)
virtual router—Virtual router used by this line user (detail only)
privilege level—Privilege level of this line user (detail only)
current command—Command currently being executed by the user over this line
(detail only)
Example 1
host1#show users
line
number line name
------ --------------
0* console 0
4 vty 3 (ftp)
5 vty 4 (telnet)
Note: '*' indicates current user.
Example 2
Chapter 5: Managing the System
connected
user from connected since
----- ---------- ----------------
console 02/12/2001 19:57
fred 10.10.0.64 02/12/2001 20:04
10.10.0.64 02/12/2001 20:04
299