Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 356

JunosE 11.3.x System Basics Configuration Guide
326
processor temperature ranges
below -5C is too cold
above 80C is too hot
low temperature warning below 10C
high temperature warning above 70C
IOA temperature ranges
below -5C is too cold
above 80C is too hot
low temperature warning below 10C
high temperature warning above 70C
Example 2—Displays the environment of an E320 router
host1#show environment all
chassis: 17 slot (id 0x3, rev. 0x0)
fabric: 100 Gbps (rev. 1)
fans: fanSubsystemOk
nvs: ok (977MB flash disk, 29% full), matches running config
power: A ok, B not present
srp redundancy: mode is file-system-synchronization
enabled, switch-on-error enabled
status unknown
*** slots: cards missing or offline
online: 0 6 13
offline: 7
empty: 1 2 3 4 5 11 12 14 15 16
fabric slots: ok
online: 6 7 8 9 10
line redundancy: none
temperature: ok
timing: primary
primary: internal SC oscillator (ok)
secondary: internal SC oscillator (ok)
tertiary: internal SC oscillator (ok)
auto-upgrade enabled
fabric redundancy: ok
*** system operational: no
slot type
---- ------------------
0 LM-4
0/1 GE-4 IOA
6 SRP-100
6 SFM-100
6/0 SRP IOA
7 SFM-100
8 SFM-100
9 SFM-100
10 SFM-100
13 LM-4
13/0 GE-4 IOA
fabric temperature ranges
below -5C is too cold
above 79C is too hot
low temperature warning below 10C
high temperature warning above 70C
processor temperature ranges
below -5C is too cold
temperature temperature
(10C - 70C) status
----------- -----------
42 normal
23 normal
32 normal
32 normal
25 normal
30 normal
23 normal
25 normal
24 normal
24 normal
23 normal
Copyright © 2010, Juniper Networks, Inc.
auto-sync