Displaying Ssh Status - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

show ip ssh
Copyright © 2010, Juniper Networks, Inc.
time the router boots after this command is issued, the SSH server daemon is not
started.
The command is not displayed by the show configuration command.
NOTE: SSH can be enabled or disabled regardless of the state of the Telnet
daemon. If SSH is enabled, use access control lists to limit access through
Telnet. See "Virtual Terminal Access Lists" on page 420 for information
about using access control lists.
Example
host1(config)#crypto key zeroize dss
There is no no version.
See crypto key dss.

Displaying SSH Status

You can monitor the current state of the SSH server with the show ip ssh command.
Use to display the current state of the SSH server.
Use the detail keyword to display the encryption and MAC algorithm lists for the client
and server. For each active session, detail shows the version of SSH running on the
client and the algorithms in use for encryption and message authentication.
Field descriptions
daemon status—Indicates whether the SSH server is enabled; if so, how long it has
been up
supported encryption, inbound—Encryption algorithms supported inbound from the
client
supported encryption, outbound—Encryption algorithms supported outbound to the
client
supported MAC, inbound—Message authentication code algorithms supported
inbound from the client
supported MAC outbound—Message authentication code algorithms supported
outbound to the client
connections since last system reset—Number of connections made through SSH
since the last time the system was reset
connections since daemon startup—Number of connections made since the SSH
server was enabled
active sessions—Number of SSH sessions currently active
Chapter 7: Passwords and Security
429