Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 100

JunosE 11.3.x System Basics Configuration Guide
Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
IPSec IKE Policy
Configuration
IPSec Manual Key
Configuration
IPSec Peer Public Key
Configuration
IPSec Transport Profile
Configuration
IPSec Tunnel Profile
Configuration
IP Tunnel Destination
Profile Configuration
70
Access to Mode
Define an IKE policy.
Enter manual keys.
Enter an ISAKMP/IKE
public key that a remote
peer uses for RSA
authentication without
the need for a digital
certificate.
Configure a profile for
L2TP over IPSec.
Configure a profile for
IPSec tunnels.
Create a profile for
dynamic GRE or DVMRP
tunnels
Exit from Mode
From the Global
Configuration mode, use
the ipsec ike-policy-rule
command.
Prompt:
host1(config-ike-policy)#
From Global Configuration
mode, use the ipsec key
manual pre-share
command.
Prompt:
host1(config-manual-key)#
From Global Configuration
mode, use the ipsec key
pubkey-chain rsa
command.
Prompt:
host1(config-peer-
public-key)#
From Global Configuration
mode, use the ipsec
transport profile
command.
Prompt:
host1(config-ipsec-transport-
profile)#
From Global Configuration
mode, use the ipsec
tunnel profile command.
Prompt:
host1(config-ipsec-tunnel-
profile)#
From Global Configuration
mode, use the gre
destination profile
command or the dvmrp
destination profile
command and specify a
destination profile name.
Prompt:
host1(config-dest-profile)#
Copyright © 2010, Juniper Networks, Inc.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.