L2Tp Tunnel Switch Profile Configuration Mode; Layer 2 Control Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

L2TP Tunnel Switch Profile Configuration Mode

Layer 2 Control Configuration Mode

96
enable Enable L2TP parameter for remote host
exit Exit from the current command mode
help Describe the interactive help system
local Configure L2TP local parameters for remote host
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
profile Assign a profile for remote host
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
tunnel Configure L2TP tunnel parameters for remote host
In this mode, you can create an L2TP tunnel switch profile, which configures the L2TP
tunnel switching behavior for the interfaces to which this profile is assigned. Issue the
avp command from this mode to define the L2TP tunnel switching behavior for a specified
L2TP attribute-value pair (AVP) type.
From Global Configuration mode, type the l2tp switch-profile command followed by an
alphanumeric profile name of up to 64 characters, and press Enter.
host1(config)#l2tp switch-profile concord
host1(config-l2tp-tunnel-switch-profile)#?
avp Configure AVP behavior
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can define session timeout values and access the L2C Neighbor
Configuration mode to specify the L2C neighbor.
From Global Configuration mode, type l2C and press Enter.
host1(config)#l2c
host1(config-l2c)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
neighbor Configure l2c neighbor parameters
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
session-timeout Configure the l2c time-out attribute
sleep Make the Command Interface pause for a specified duration
Copyright © 2010, Juniper Networks, Inc.