Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 99

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Interface Configuration
IP NAT Pool
Configuration
IP PIM Data MDT
Configuration
IP Service Profile
Configuration
IPSec CA Identity
Configuration
IPSec Identity
Configuration
Copyright © 2010, Juniper Networks, Inc.
Access to Mode
Create an interface.
Modify the operation of
an interface, such as
bandwidth or clock rate.
Create a NAT pool with a
multiple, discontinuous
range.
Create and activate data
multicast distribution
trees (MDTs)
Create a service profile to
use in route maps for
subscriber management
and to authenticate
subscribers with RADIUS.
Create an IPSec identity
used in online certificate
requests and during
negotiations with IKE
peers.
Create an IPSec identity
used in offline certificate
requests and during
negotiations with IKE
peers.
Exit from Mode
From Global Configuration
mode, use the interface
command and identify the
interface by slot/port.
Prompt:
host1(config-if)#
From Global Configuration
mode, use the ip nat pool
command and specify
only a prefix length value.
Prompt:
host1(config-ipnat-pool)#
From Global Configuration
mode, use the ip pim
data-mdt command and
specify a name.
Prompt:
host1(config-ip-pim-
data-mdt)#
From Global Configuration
mode, use the ip
service-profile command
and specify a service
profile name with up to 32
ASCII characters.
Prompt:
host1(config-service-
profile)#
From the Global
Configuration mode, use
the ipsec ca identity
command.
Prompt:
host1(config-ca-identity)#
From the Global
Configuration mode, use
the ipsec identity
command.
Prompt:
host1(config-ipsec-
identity)#
Chapter 2: Command-Line Interface
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
69