Configuring Vrrp; Configuring Routing Policy; Configuring Qos - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x System Basics Configuration Guide

Configuring VRRP

Configuring Routing Policy

Configuring QoS

24
Data mapping—The process of getting data packets onto an established LSP.
See JunosE BGP and MPLS Configuration Guide , for information about configuring
MPLS.
In addition, if you want to make configuration adjustments to IP, see JunosE IP, IPv6, and
IGP Configuration Guide, for details.
The Virtual Router Redundancy Protocol (VRRP) can prevent loss of network connectivity
to end hosts if the static default IP gateway fails. By implementing VRRP, you can
designate a number of routers as " backup" routers in case the default " master" router
fails. You can configure VRRP on IP/Ethernet interfaces.
For information about configuring VRRP, see JunosE Services Availability Configuration
Guide.
The router supports a number of features that allow the service provider to control the
exchange of routing information between virtual routers in the router, between routers
in the network, and between protocols within a router:
Access lists—Provide filters that can be applied to route maps or distribution lists. They
allow policies to be created, such as a policy to prevent forwarding of specified routes
between the BGP-4 and IS-IS routing tables.
Route maps—Modify the characteristics of a route (generally to set its metric or to
specify additional attributes) as it is transmitted or accepted by a router. Route maps
can use access lists to identify the set of routes to modify.
Distribution lists—Control the routing information that is accepted or transmitted to
peer routers. Distribution lists always use access lists to identify routes for distribution.
For example, distribution lists could use access lists to specify routes to advertise.
Redistribute routes—Allow routes to be shared between routing protocols and routing
domains. For example, a subset of BGP-4 routes could be leaked into the IS-IS routing
tables.
See JunosE IP Services Configuration Guide, for details.
QoS is a suite of features that configure queuing and scheduling on the forwarding path
of your E Series router. QoS provides a level of predictability and control beyond the
best-effort service that is the E Series router's default data delivery service. Packets not
assigned to a specific traffic class are carried in the best-effort traffic class. Best-effort
service provides packet transmission with no guarantee of results.
The major QoS features that the E Series router provides are:
Copyright © 2010, Juniper Networks, Inc.