Monitoring Events - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

trigger

Monitoring Events

To view the status of the SNMP agent, use the following show snmp agent command.
To view statistics associated with events, resources, and triggers, use the show snmp
management-event command.
show snmp agent
Example 2 Specifying a startup threshold condition
host1(config-mgmtevent-trigger)#threshold-test startup rising
Example 3 Binding an event to the threshold-test trigger
host1(config-mgmtevent-trigger)#threshold-test event sysadmin failureTrigger
Use the no version to delete the threshold-test values for this trigger or remove
either the threshold startup condition or event binding.
See threshold-test.
Use to create a trigger and access the trigger configuration mode of the SNMP
server event manager.
Example
host1(config-mgmtevent)#trigger fred trigger1
host1(config-mgmtevent-trigger)#
To leave the trigger configuration mode, use the exit command.
Use the no version to remove the trigger.
See trigger.
Use to view SNMP MIB agent information.
Field descriptions
context name Router that contains the MIB agent
access permission level Access permission level for other virtual routers
that may want to access the agent
snmp proxy Proxy gateway through which other virtual routers may access
the agent
Example
host1#show snmp agent
context name: router1
access permission level: no access
snmp proxy: enabled
See show snmp agent.
Chapter 4: Configuring SNMP
Configuring the SNMP Server Event Manager
189