Vr Group Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual

VR Group Configuration Mode

Copyright © 2010, Juniper Networks, Inc.
From Global Configuration mode, type ip vrf and the vrfName, and press Enter. Confirm
the new VRF by pressing Enter.
host1(config)#ip vrf yankee
Proceed with new vrf creation? [confirm]
host1(config-vrf)#?
default Set a command to its default(s)
description Configure VRF specific description
do Run an exec mode command (alias command run)
exit Exit from the current command mode
export Specify VRF export characteristics
help Describe the interactive help system
import Specify VRF import characteristics
ip Configure IP characteristics
log Configure logging settings
macro Run a CLI macro
maximum Specify a maximum limit
no Negate a command or set its default(s)
rd Specify route distinguisher
route-target Specify VPN extended community Target
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
In this mode, you can add up to four virtual routers to the virtual router group. The
accounting servers of the virtual routers in the group can receive AAA broadcast
accounting records.
From Global Configuation mode, type aaa accounting vr-group and the vrGroupName,
and press Enter.
host1(config)#aaa accounting vr-group westVrGroup38
host1(config-vr-group)#?
aaa Configure authentication, authorization, and accounting
characteristics
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
support Enter Support mode
Chapter 2: Command-Line Interface
115