Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 222

JunosE 11.3.x System Basics Configuration Guide
bulkstats receiver remote-name
bulkstats traps
bulkstats virtual-router-group
192
Use the no version to delete the interface type from bulk statistics collection. Deletion
of a particular interface type takes effect at the next collection interval.
See bulkstats interface-type.
Use to configure the parameters for receivers.
Bulk statistics transfers require the configuration of a remote FTP server.
The receivers must appear in the FTP host table. The name of the host must match
the name you specify with this command. The hostname is relative to the virtual router's
context when you issue this command.
When specifying the remote filename for bulk statistics, you must precede the filename
with the hostname followed by the :/ characters.
Example
host1(config)#bulkstats receiver 1 remote-name js:/ftptest/bulk%s%s.sts sysName
sysUpTime
NOTE: The % variables in the remote name are replaced at runtime with
the sysName and sysUpTime parameters to produce variable filenames
on the remote host.
Use the no version to delete the receiver.
See bulkstats receiver remote-name.
Use to configure bulk statistics traps.
You must configure SNMP correctly and specify a valid trap source. Otherwise, the
system will not send SNMP traps.
Example
host1(config)#bulkstats traps nearly-full
Use the no version to disable the trap.
See bulkstats traps.
Use to collect interface statistics for each virtual router.
A collector can have a maximum of 64 virtual routers associated with it.
Routers are identified by their assigned name or router index.
Supported only on if-stats and igmp schemas.
Supported on all interface types supported by the bulk statistics application.
Copyright © 2010, Juniper Networks, Inc.