Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual page 206

JunosE 11.3.x System Basics Configuration Guide
resource
sample
set
snmp-server management-event
176
Use the no version to remove the notification from the event. Removal returns the
notification value to its default (0.0)
See notification id.
Use to specify the total number of triggers that the virtual router allows.
CAUTION: When assigning wildcards, make sure to allow for enough trigger
resources.
Example
host1(config-mgmtevent-event)#resource 250
Use the no version to restore the default resource value (50).
See resource.
Use to specify the MIB object that you want to sample for the trigger that you are
configuring.
Example
host1(config-mgmtevent)#sample value-id 1.3.6.1.2.1.60.1.2.1.1.7
Use the no version to remove the MIB object from the trigger. Removal returns the
sample value-id to its default (0.0).
See sample.
Use to perform an SNMP set operation under certain event conditions.
Example—Sets the administrative status of interface 123 to down (2)
host1(config-mgmtevent-event)#set context-name router1
host1(config-mgmtevent-event)#set id 1.3.6.1.2.1.2.2.1.7.123
host1(config-mgmtevent-event)#set value 2
Use the no version to remove the set operation.
See set.
Use to launch the SNMP server event manager mode on each virtual router on which
you plan to manage events.
Example
host1(config)#snmp-server management-event
host1(config-mgmtevent)#
Copyright © 2010, Juniper Networks, Inc.